12 Volt Basic Three Phase Wind and Solar Controller w/ LED Display

Wood Profits Banner



buy now

$197.89



Comes prewired for plug and play with: 3-phase brake switch charge controller with LED volt meter relay heavy duty battery cables and rectifier for 3-phase output wind turbine connection You can also attach additional DC wind turbines and solar panels to the board. Assembled and quality checked by Missouri Wind and Solar in Seymour, Missouri. Pair with your preferred dump/divert load for use with your wind turbine Some of the key features of this hybrid controller are: Dual microprocessor controlled for stability and accuracy Multiple user changeable settings and trip points for many various system requirements and applications. You can change the dump point voltage level, end of dump voltage level, and length of time in divert mode when end dump point voltage is reached (between 0 to 999 seconds, or 0 to 999 minutes) Isolated Electronics Protection – Almost impossible to accidentally connect wind or solar directly to the circuit board On board relay isolates electronics from back voltage spikes from large 440 amp relay. This is important to get the longest life out of the electronics. No one else has this! High amp rating: 440 amps, 10,000 watts. Plug & Play: Long leads for easy termination to your 12 volt battery or battery bank Can divert the charging source from the batteries to the load or dump both the batteries along with the charging source. Connect both wind and solar at the same time Reverse polarity protection Ultra low power consumption, even with the volt meter on (almost negligible).The volt meter can be set to turn off after periods of inactivity. Comes with 5 feet of heavy duty cables. Comes completely prewired as shown above. Mounting Plate Dimensions: 8 inches x 12 inches Battery not includedMissouri Wind 12 Volt 440 Amp/10,000 Watt Hybrid Wind and Solar Basic Charge Controller now with LED meter that shows battery voltage.
Dual microprocessor controlled for stability and accuracy
Multiple user changeable settings and trip points for many various system requirements and applications. You can change the dump point voltage level, end of dump voltage level, and length of time in divert mode when end dump point voltage is reached (between 0 to 999 seconds, or 0 to 999 minutes)
Isolated Electronics Protection – Almost impossible to accidentally connect wind or solar directly to the circuit board
On board relay isolates electronics from back voltage spikes from large 440 amp relay. This is important to get the longest life out of the electronics.

Share