DROK DC-DC Buck Converter Constant Current&Volt Regulator 5-36V to 1.25-32V Step Down Regulator 5A 75W High Power LED CC Driver Board, Battery Charger for Solar Panels/Wind Driven Generator | Solar & Wind Products; View Hundreds of Solar & Wind Products Here!

DROK DC-DC Buck Converter Constant Current&Volt Regulator 5-36V to 1.25-32V Step Down Regulator 5A 75W High Power LED CC Driver Board, Battery Charger for Solar Panels/Wind Driven Generator



buy now

$17.28



Parameters:
Input voltage : 5-36V (the input voltage should at least 1.5V higher than the output voltage)
Output voltage :1.25-32V (continuously adjustable,default output 17V.)
Output Current : 5A MAX(Please use it within 4.5A)
Output Power: Max 75W (Please use it within 50W. if the pressure difference is big,please reduce power)
Operating temperature: -40 to +85 ° C
Operating frequency: 180KHz
Conversion efficiency : up to 96%
Short circuit protection: Yes
Overtemperature protection: (automatically shut off the output after overtemperature)
Input reverse polarity protection: No, (if necessary, please in input
String into high current diode)
Installation: 4pcs 3mm screws
Wiring:(solder terminals) V-IN is the input, V-OUT is the output

Usage:
1. Use as an ordinary buck module with overcurrent protection capabilities;
2. Use as a battery charger;
3. Use it as a constant current LED driver module.

Note:
1. If the module can not be adjusted, the output voltage is always equal to the input voltage.” When you encounter this problem, please counterclockwise rotation of the potentiometer 10 laps or more, then you can adjust the output voltage. Because the factory default output voltage is 17V.
2.Module output terminal string has a current sampling resistor, there will be 0-0.2V voltage drop after connected to the load, it is a normal phenomenon.
3.If its output is more than 3A/35W, please enhance heat dissipation!

4.This DC {solar lights}is single output, the output voltage of the USB port is the same as the output voltage of the module, if your load is USB device, please make sure the module’s output voltage is set at 5V.

Package include:
1 x Buck Converter
DROK buck {solar lights}input voltage range is 5-36V, output voltage range is 1.25-32V continuously adjustable, default output 17V, max output current is 5A(please use it within 4.5A).
With voltmeter/ammeter/power meter itself, can be directly used without outside multimeter.
Can be buck {solar lights}with over current protect function, won’t be burned even if short circuit.
Can be a constant current LED driver module; also can be a battery charger for {solar lights}, wind driven generator.
With USB port, can be used to charge for digital products.(Note: USB output voltage is the same as the module voltage output, please check before using.)

{solar lights} & Wind EBooks
Share Button

Leave a Reply

Your email address will not be published. Required fields are marked *


Solar Power Generators